
Caulk strips and tools · Caulk accessory
Homax Caulk Tip and Cap
Best for Resealing an open cartridge between jobs
Opens our retail partner in a new tab. Payment, delivery and returns happen there.
- Size
- 1/2, 1/4 and 1/8 in bead tips
Features
Features
- Three tips for 1/2, 1/4 and 1/8 inch beads
- Each tip molded at a 45 degree angle
- Stackable tips switch bead size on one cartridge
- Resealing cap for tubes and cartridges between jobs
- Fits standard tubes and cartridges by hand
- For caulk, adhesive and sealant
Specifications
Specifications
| Brand | Homax |
|---|---|
| Item number | 2406 |
| Type | Caulk accessory |
| Shelf | Caulk strips and tools |
| Size | 1/2, 1/4 and 1/8 in bead tips |
For best results
For best results
- Clean the tips right after use, before the material sets inside them.
- Start with the smallest bead and step up only if the joint needs more.
How to use
How to use
- Step 1Pick the bead size you need and screw that tip onto the tube.
- Step 2Run the bead with the angled tip held flat to the joint.
- Step 3Stack a larger or smaller tip when the joint changes width.
- Step 4Screw on the cap when you finish so the tube stays usable.
About this product
One tube, three bead sizes, and a cap for later
Cutting a caulk nozzle is a one-way choice: cut too far and every bead runs fat. Homax Caulk Tip and Cap swaps that guess for three preformed tips that screw onto a standard tube or cartridge. They give you a 1/2, 1/4 or 1/8 inch bead, each molded at a 45 degree angle.
The tips stack, so you can go from a small bead to a large one and back again on the same cartridge. When you stop for the day, the resealing cap keeps the open tube from drying out. The set works with caulk, adhesive and sealant, and you can reuse it on the next job.
The caulk strips and tools shelf holds 8 more products beside the Caulk Tip and Cap, and every one belongs to the Homax texture and repair range.